commit 4d26f7 "regulator: max8660: Use devm_kzalloc()" missed to
replace kzalloc by devm_kzalloc. Fix it.
Signed-off-by: Axel Lin <axel.lin@gmail.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Current DA7210 driver does support PLL mode fully. It uses fixed
value of input master clock and PLL mode is enabled and disabled based
on the sampling frequency being used for playback or recording. It also
doesn't support Sample Rate Measurement feature of DA7210 hardware.
This patch adds full support for PLL and SRM. Basically following three
modes of operation are possible for DA7210 hardware,
(1) I2S SLAVE mode with PLL bypassed
(2) I2S SLAVE mode with PLL enabled
(3) I2S Master mode with PLL enabled
This patch adds support for all three modes. Also, in case of SLAVE mode
with PLL, it supports SRM (Sample Rate Measurement) feature of the chip.
Actually this patch was submitted earlier and received some review
comments, but after that the driver got update by other patches. Because
of that, I am considering this as new patch and not versioning it based
of previous patches. This version tries to take care of all review
comments received for earlier submissions.
Signed-off-by: Ashish Chavan <ashish.chavan@kpitcummins.com>
Signed-off-by: David Dajun Chen <dchen@diasemi.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Add an entry for the Timer Counter (TC) library and the clocksource
driver that is using this library.
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Add missing DMI_NONE entry to end of the quirks list so
dmi_check_system() won't read past the end of the list.
Signed-off-by: Martin Nyhus <martin.nyhus@gmx.com>
Signed-off-by: Matthew Garrett <mjg@redhat.com>
We can't control order here, and getting it inverted is harmless. So
turn this down to dev_info() and leave a note about how to fix it in
case userspace is insufficiently automagic.
Bugzilla: https://bugzilla.redhat.com/794953
Signed-off-by: Adam Jackson <ajax@redhat.com>
Signed-off-by: Matthew Garrett <mjg@redhat.com>
This will enable all current SoC support on DT (9260, 9g20, 9g45 family
and 9x5 family).
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
This will allow to add any board to a compiled kernel by just passing the DTB.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
We can now compile all SoC core support together and DT boards.
We still can not compile together the non DT board.
So We keep the ARCH_AT91xxx for the non DT board and for backward defconfig
compatibility. This will enable the plaform_device ressources.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
This will allow to simplify the switch to multi soc in the same kernel.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Those are used to program the WRPLL dividers correctly for each gives
frequency.
Signed-off-by: Eugeni Dodonov <eugeni.dodonov@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Compared with previous chipsets, it needs no special action trough the
jumbo{enable/disable} helpers to operate with jumbo frames.
Signed-off-by: Hayes Wang <hayeswang@realtek.com>
Acked-by: Francois Romieu <romieu@fr.zoreil.com>
Adjust r810x_pll_power_down, r810x_pll_power_up, and r8168_pll_power_up.
Always power up device during rtl_open. For r810x, turn off more power
when the WOL is disabled.
Signed-off-by: Hayes Wang <hayeswang@realtek.com>
Our workaround list kindly lists that this new default value needs to
be updated in Bspec. Naturally, this did not happen.
Acked-by: Ben Widawsky <ben@bwidawsk.net>
Signed-Off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
According to Bsepc, this should be set by default, but isn't. See vo1c.4
"Render Engine Command Streamer", Section 1.1.14.3 "3D_CHICKEN3"
Bspec also says that we always need to set all mask bits.
v2: Add comment about the mask bits wtf.
Reviewed-by: Ben Widawsky <ben@bwidawsk.net>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
For some reason snb has 2 fields to set ppgtt cacheability. This one
here does not exist on gen7.
This might explain why ppgtt wasn't a win on snb like on ivb - not
enough pte caching.
v2: Fixup rebase fail.
Reviewed-by: Ben Widawsky <ben@bwidawsk.net>
Signed-Off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Bspec says that we need to set this: vol1c.3 "Blitter Command
Streamer", Section 1.1.2.1 "GAB_CTL_REG - GAB Unit Control Register".
We don't really rely on pagefaults, but who knows what this all
affects.
Reviewed-by: Ben Widawsky <ben@bwidawsk.net>
Signed-Off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Contrary to the other clock gating w/a in GEN6_UCGCTL1, this one is
actually documented in Bspec, vol1g "GT Interface Registers [SNB]",
Section 1.5.1 "UCGCTL1 - Unit Level Clock Gating Control 1".
Supposedly this can prevent hangs on the media ring.
Reviewed-by: Ben Widawsky <ben@bwidawsk.net>
Signed-Off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
Backmerge Linux 3.4-rc3 into drm-intel-next to resolve a few things
that conflict/depend upon patches in -rc3:
- Second part of the Sandybridge workaround series - it changes some
of the same registers.
- Preparation for Chris Wilson's fencing cleanup - we need the fix
from -rc3 merged before we can move around all that code.
- Resolve the gmbus conflict - gmbus has been disabled in 3.4 again,
but should be enabled on all generations in 3.5.
Conflicts:
drivers/gpu/drm/i915/intel_i2c.c
Signed-Off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
This will also allow to finally move the gpio driver to platform device/driver.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
There is no need to pinmux the UART so early in the kernel.
Move it to the board init.
This will also allow to finally move the gpio driver to platform device/driver.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
at91_set_serial_console is used to define the default console of linux.
This is already manage by the cmdline. And if the boot loader can not be
modified you can still set it by enabling the CONFIG_CMDLINE_EXTEND option.
And then the command-line arguments provided by the boot loader will be
appended to the default kernel command string.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
This will now autodetect the first uart enabled by the bootloader
and will use it for uncompress. This will still assume that the bootloader
configured it (pins and clock).
This also allows to include all soc headers together.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
This will allow a future change to auto-detect which UART to use.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Indentation was already done mainly with spaces, so this commit
removes the tabs and makes some of the whitespace more consistent.
Signed-off-by: Michael Witten <mfwitten@gmail.com>
Acked-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
The nature of the patches for the -stable kernels was discussed
twice; this commit consolidates those discussions into one
paragraph.
Signed-off-by: Michael Witten <mfwitten@gmail.com>
Acked-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Mainly, this just separates paragraphs, so that the text is easier
on the eyes.
Signed-off-by: Michael Witten <mfwitten@gmail.com>
Acked-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Also, one `Alternate' was changed to `Alternative' for the
sake of consistency.
Signed-off-by: Michael Witten <mfwitten@gmail.com>
Acked-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
For the most part, this commit simply introduces commas to
offset modifiers.
Signed-off-by: Michael Witten <mfwitten@gmail.com>
Acked-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
The text referred to `XX', when only a single `X' actually
existed, so this commit changes it to just `X'; a similar
change has been made for `xx'.
Also, `N' was used when it would have been more consistent
to use `X' again, so this commit replaces `N' with `X'.
This commit also chooses to leave `X' as the placeholder
for the current version of the source, and then makes `x'
the placeholder for any version number; fortunately nothing
really depends on this subtlety being understood.
Because `x' is already being used when discussing version
numbers, this commit changes such filename references as
`xxx.rej' to `some-file-name.rej'.
Signed-off-by: Michael Witten <mfwitten@gmail.com>
Acked-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
